The Clean Power Center is a 10 outlet high quality, non-current limiting, noise filtering power conditioner. It features the same heavy construction and quality as our Ultra Power Isolators, minus of course, the balanced isolation transformer.
Features include: 10 high current premium Hubbell 5362 outlets, 12 gauge finely stranded Oxygen Free Copper wiring, removable power cord, advanced spike/surge protection, on/off magnetic breaker switch, heavy case damping, high-quality parallel filter network on each duplex for complete component isolation.
The CPC is available as a 15-amp version with 15-amp IEC or 20-amp unit with 20-amp IEC. Includes our C-9 audiophile grade power cord.
10 lbs. 14"Wx8"Dx6"H chassis 15A or 20A versions--$499
Upgrades Options:
Signature PLUS Upgradefor CPC. The Signature PLUS Upgrade is a combination of our best options for the very finest performance possible. Includes set of 4 Iso-Cones, 1/4" thick machined aluminum faceplate, EP-2000 filter/suppressor, top of the line Rhodium plated Furutech IEC inlet, copper foil shielding on chassis interior, Oyaide outlets, 6' L-9C power cord and customers choice for chassis wiring of our 12 AWG 4N Oxygen Free Copper Litz stranded wire, 10 AWG 4N pure silver solid wire or 12 AWG 6N UP-OCC stranded copper wire- - $1550 for 15A version or $1800 for 20A version (save up to $100 over individual upgrade pricing).
Oyaide SWO-XXX - 15A design, Gold and Palladium plated bronze, superb construction and sound - $99 ea. (SWO-DX and SWO-GX available on special order)
Furutech FI-09R 15A IEC inlet - Heavy duty Rhodium plated pure copper conductor - $80 ea.
Furutech FI-33R 20A IEC inlet - Heavy duty Rhodium plated pure copper conductor - $100 ea.
V-Cap Teflon Capacitors - Teflon capacitor used in the filtering network - $125-$180 per duplex
Bybee Quantum Purifiers--increases resolution - $200 [set of 2]
EP-2000-- parallel high current surge suppression and line filtering (neutral sounding with no power insertion loss) available for our CPCs, PPC or any of our Balanced Power Isolators. - $400
The EP-2000 system (a patented design, manufactured for BPT by our friends at Environmental Potentials Inc.) is designed to suppress power line induced voltage surges up to 10,000 volts, which is approximately three times greater than the industry recognized statistical average of such surges entering a facility. It operates upon the principle of selective filtering, time spreading and absorption of voltage waveform anomalies induced onto and riding on a line frequency sinusoidal power wave. At the instant a high voltage transient or surge appears on the line frequency wave, it is clamped at a level just above the peak value of the sinusoid. This clamping action creates an amount of energy determined by the difference in the clamping voltage and the peak voltage of the transient, the impedance of the clamping device within the EP-2000, and the time duration of the transient. A solid state component designed for fail-safe performance. Includes LED for instant visual confirmation that the EP2000 surge/filtration system is fully active. If the EP2000 module should ever fail or loose its full capability for surge suppression, it can easily be replaced.
·Removes, absorbs and dissipates transient voltage surges and spikes, high frequency noise and ring waves
·Frequency Attenuation: -20 dB/decade roll-off starting at 2.5kHz
·MaxSurge current: 25kA per mode
·Provides both common and transverse modes of protection
·Extends life of all equipment connected
HCF-30 - A 30-amp high current filter with extremely low power insertion loss. We chose this very high current device in order to prevent any possibility of dynamic compression when used in our Clean Power Center - $150 (not available for the PPC)
Frequency Response: 5 KHz to 100 MHz
Maximum attenuation: 65 dB
Machined aluminum faceplate - this 1/4" thick machined, polished and coated panel that perfectly complements our Balanced Power Isolators or CPC $75 [black or silver]. (not available for the PPC)
Copper Foil Shield - we line the interior of the chassis with copper foil to create an all encompassing barrier against RFI penetration - $75.
Iso-Cones - Custom made 1" machined 316 stainless steel isolation cones with matching protective disc (to protect wood floors or shelving). These can be used as standalone cones for any piece of gear or as a direct screw in replacement footer for our balanced isolators or CPC (matching 1/4" threaded stud included). $75 for a set of four or $60 for a set of three.
4N OFC Copper Litz wiring--unit is internally wired with our custom 12 AWG Oxygen Free Copper Litz stranded copper wiring for faster transient response, uncolored midrange and tight bass. This wiring matches our L-9C power cord. - $50.
4N Silver wiring (double annealed)--unit is internally wired with our custom high purity 10AWG solid silver wiring in a Teflon jacket for superb low level detailing and a warm, organic midrange. - $75
6N UP-OCC Copper wiring--unit is wired with ultra pure single crystal 12 AWG stranded copper wire for excellent low level detailing, neutral tone and smooth sound. - $100
